Ask Your Question

Angie's List Answers is the trusted spot to ask home improvement and health questions and get answers from service companies, health providers and consumers. For ratings and reviews on companies in your area, search Angie's List.

 
 
or
Submit
Top 30 Days Experts
Rank Leader Points*
1 kstreett 240
2 Guest_9020487 110
3 Guest_9190926 105
4 GoldenKid 100
5 ahowell 95
6 KnowledgeBase 95
7 skbloom 80
8 Guest_98024861 70
9 Guest_9311297 70
10 Guest_9400529 70

*Updates every 4 hours

Browse Projects By Category

Question DetailsAsked on 1/29/2017

Cost to replace 7,420 FT2 of aluminum siding with natural stone veneer.

What is approximate cost to replace 7,420 FT2 of aluminum siding with natural stone veneer. I have deducted the square footage of one small door and two large windows. The height of stone will be 9'6".

Do you have the same question? Follow this Question


1 Answer

0
Votes

Here links to a previous similar question with answers FYI -


http://answers.angieslist.com/How-sto...


Common numbers (realize these are ballpark, dependent on product quality, local labor rates, access and site-specific factors (like height off ground, plantings near wall that need protecting, weather, etc) are about $4-10/SF for fake or "cultured" veneer panels made of stamped/formed fiberglass or plastic which are screwed or nailed onto the wall in sheets, around $8-15/SF for "synthetic" veneer which are fake stone applied like real stone - $12-20 for cheaper commonly available and cheap to make stone grades like limestone or shale and shales, more like $25-50/SF for higher-quality true stone veneer like granite or slate. These numbers for typical 4" or thinner veneer - if you mean true staked cut stone which might run up to a foot thick (and hence not a "veneer" but rather a "facade" or "facing", because of the greater foundation and wall structure requirements, commonly about $10-20/SF more for that.


Removal of the existing siding and placement of insulation / water barrier can typically run a couple to a few dollars/SF EACH on top of that - and usually the existing water barrier is NOT suitable for reuse.


For this size job definitely get several bids from General Contractors or Masonry contractors - because you can expect a wide variation on pricing, so I would be looking at probably a half dozen bids to be able to tell which are lowball, which are in the reasonable range, and which way too high. This is a big job for veneer, so you should have no problem getting bids.


And be sure to tie down the exact product you want in initial site visits - and tell them that until you see their products and decide which one you want, you don't want bids - then notify them mall what exact product (from samples they showed you or yuou found at a store) you want and have them ALL bid the exact same scope of work with the same product, so you can compare apples to apples.

Answered 1 year ago by LCD




Related Questions


Terms Of Use
|
Privacy Policy