Ask Your Question

Angie's List Answers is the trusted spot to ask home improvement and health questions and get answers from service companies, health providers and consumers. For ratings and reviews on companies in your area, search Angie's List.

 
 
or
Submit
Top 30 Days Experts
Rank Leader Points*
1 kstreett 240
2 Guest_9020487 110
3 Guest_9190926 105
4 GoldenKid 100
5 ahowell 95
6 KnowledgeBase 95
7 skbloom 80
8 Guest_98024861 70
9 Guest_9311297 70
10 Guest_9400529 70

*Updates every 4 hours

Browse Projects By Category

Question DetailsAsked on 8/29/2016

I had tight many time rocker after the tighten rocker generator start but after switch off it did not star again

Do you have the same question? Follow this Question


1 Answer

0
Votes

You may have to respond back (using the Answer This Question yellow button right below your question), because I am not getting the whole picture here. Sounds like you tightened your rocker or rocker/recliner (power lift type maybe ?) but the next time you tried to use it the motor did not work?


1) may be you overtightened it, and just loosening it a bit will allow the motor to work right


2) overtightening may have tripped a built-in thermal overload breaker on the motor - loosen the pivot back up a bit, unplug chair and check on the motor (likely will have to turn chair over) to look for a small red button on the motor. Will typically say "Push to Reset" or such - push in till it clicks, set chair back up, plug back in and try again.


3) if you have a remote control on a cord, make sure it did not get unplugged or partly disconnected while tightening the chair pivot.


4) or, overtightening may have burned out the motor - in which case you would need a Furniture Repair and Refinishing company, or a specific local vendor who services that make - try manufacturer website for local repair company name and address.


=======

If you mean a baby rocker, if battery operated check for batteries being securely in place (may have gottne loosen up in the tightening process), and check it rocks freely - might have tightened it too much. Otherwise, if battery operated, batteries may have just chosen that moment to go dead. Try a new set of batteries to see if that is the problem.

Answered 2 years ago by LCD




Related Questions


Terms Of Use
|
Privacy Policy